specifiion for crushed aggregate surface course

STANDARD SPECIFICATIONS FOR BITUMINOUS

Mixtures and Surface Treatments" in these specifiions. When a Special Wear Course is specified, the aggregates used in the Special Wear Course shall be 100 percent crushed mine trap rock, quartzite or granite or shall consist of 100 percent crushed natural gravel.

Contrast quote

Chapter 620 Design of Pavement Structure

Consider the inclusion of crushed surfacing top course material for keystone when estimating The specific gravity of the aggregate will affect the weight of aggregate in the completed mix. [2] Quantities shown do not provide for widening, waste from stockpile, or thickened edges. Chapter 620 Design of Pavement Structure WSDOT Design Manual

Contrast quote

state.mn.us

Crushed Concrete and Salvaged Aggregate The Contractor may incorporate no greater than 50 percent of crushed concrete and salvaged aggregate in nonwear mixtures. Do not use crushed concrete in wearing courses. 13.10 Ash Sewage sludge ash and waste incinerator ash are allowed as an aggregate source at a maximum of 5% of

Contrast quote

Standard Specifiion for Materials for SoilAggregate

D124115 Standard Specifiion for Materials for SoilAggregate Subbase, Base, and Surface Courses surface course~ subbase course~ ~ Products and Services / Standards & Publiions / Standards Products. ASTM D1241 15 Standard Specifiion for Materials for SoilAggregate Subbase, Base, and Surface Courses.

Contrast quote

ASTMD1241 Standard Specifiion for Materials for Soil

ASTMD1241 Standard Specifiion for Materials for SoilAggregate Subbase, Base, and Surface Courses coarse aggregate crushed stone fine aggregate gradation granular materials gravels soil–aggregate subbase, base, and surface courses ICS Number Code 93.020 (Earth works. Excavations. Foundation construction. Underground works)

Contrast quote

Asphalt Concrete Base (ACB) Pavement Interactive

Asphalt concrete base (ACB), also called asphalt treated base (ATB), is a densegraded HMA with a larger nominal maximum aggregate size (1 inch) intended for use as a base course or binder course (see Figure 1). In addition to site paving benefits, ACB can be advantageous because it can provide: A waterproof barrier to prevent fines infiltration into the subgrade and pavement structure.

Contrast quote

ASTM D196 Specifiion for Crushed Stone, Crushed Slag

ASTM D692/D692M Standard Specifiion for Coarse Aggregate for Bituminous Paving Mixtures Published by ASTM on June 1, 2015 This specifiion covers crushed stone, crushed hydrauliccement concrete, crushed blastfurnace slag, crushed gravel, crushed expanded shale, crushed expanded clay, and crushed expanded slate

Contrast quote

ASTMD1241 Standard Specifiion for Materials for Soil

ASTMD1241 Standard Specifiion for Materials for SoilAggregate Subbase, Base, and Surface Courses coarse aggregate crushed stone fine aggregate gradation granular materials gravels soil–aggregate subbase, base, and surface courses ICS Number Code 93.020 (Earth works. Excavations. Foundation construction. Underground works)

Contrast quote

TxDOT Specifiions dot.state.tx.us

Mar 05, 2004 ·縮 AGGREGATES FOR SURFACE TREATMENTS. SPECIFICATION REQUIREMENTS 1) Type(s) and grade(s) of aggregate must be shown on the plans. 2) Specify Surface Aggregate Class. 3) Specify any additives or antistrip if desired. 4) Show on the plans if Flakiness index is to be other than 17 max.

Contrast quote

STANDARD SPECIFICATIONS FOR CONSTRUCTION OF

STANDARD SPECIFICATIONS FOR CONSTRUCTION OF ROADS AND BRIDGES ON FEDERAL HIGHWAY PROJECTS FP14 . U.S. Department of Transportation . Federal Highway

Contrast quote

ITEM P208 AGGREGATE SURFACE COURSE dot.state.ak.us

P2081 5/09 ITEM P208 AGGREGATE SURFACE COURSE DESCRIPTION . 2081.1 This item consists of an aggregate surface course composed of crushed or uncrushed coarse aggregate bonded with either soil or fine aggregate or both. It shall be constructed on a prepared course

Contrast quote

02204 Base Course Juneau

equipment necessary for furnishing and placing one or more layers of aggregate base or leveling course on a prepared surface to the lines and grades shown on the Drawings. PART 2 PRODUCTS 2.1 MATERIAL A. Aggregate base course shall consist of crushed gravel or crushed stone, conforming to the quality requirements of AASHTO M 147.

Contrast quote

19 Spec Section 301 Base, Subbase, and Subgrade Aggregate

Aggregate A composite mixture of hard, durable mineral materials that have been mechanically processed. Breaker run Aggregate resulting from the mechanical crushing of quarried stone or concrete not screened or processed after primary crushing. Crushed gravel Crushed angular particles of gravel retained on a No. 10 sieve.

Contrast quote

Recycled Materials Specifiions

Aggregates. Specifiion 902: Fine Aggregate Local materials Any materials meeting requirements for size, hardness and durability. Screenings from reclaimed Portland Cement Concrete pavement. Specifiion 334: Crushed Glass (not in surface course) Specifiion 901: Coarse Aggregate Reclaimed Portland Cement Concrete.

Contrast quote

ASTM D1241 15 Standard Specifiion for Materials for

1.1 This specifiion covers the quality and grading of the following materials for use in the construction of subbase, base, and surface courses: sandclay mixtures gravel stone or slag screenings sand crusherrun coarse aggregate consisting of gravel, crushed stone, or slag combined with soil mortar or any combination of these materials. . The requirements are intended to cover

Contrast quote

Airport Construction Standards (AC 150/537010) – Airports

Provides individual specifiions from AC 150/537010, Standards for Specifying Construction of Airports, including construction standards for general provisions, earthwork, flexible base courses, rigid base courses, flexible surface courses, rigid pavement, fencing, drainage, turfing, lighting installation, pavement rejuvenation

Contrast quote

Item 00231 Cements Stabilized Crushed Aggregate Base

TECHNICAL SPECIFICATION ITEM 00231 CEMENT STABILIZED CRUSHED AGGREGATE BASE COURSE 231.1 Description. This item shall consist of a foundation for surface course or for other base courses and shall be composed of a mixture of crushed aggregate, Portland cement and water and

Contrast quote

Bulletin Trail Surface Aggregate (TSA)

"downsizing" of the successful and popular Driving Surface Aggregate (DSA) developed for use on roads. Specifiion: All TSA material is to be derived from natural stone formations. Stone is defined as rock that has been crushed rock is defined as consolidated mineral matter. Both are restricted to that which has been mined or quarried from

Contrast quote

32 11 23 Aggregate Base Course udfcd.org

a. M147, Standard Specifiion for Materials for Aggregate and SoilAggregate Subbase, Base, and Surface Courses. b. T11, Standard Method of Test for Materials Finer Than 75 m (No. 200) Sieve in Mineral Aggregates by Washing. c. T27, Standard Method of Test for Sieve Analysis of Fine and Coarse Aggregates.

Contrast quote

ITEM 73 AGGREGATES 73.01 FINE AGGREGATE FOR

Crushed Slag, and Crushed Gravel for OpenGraded Bituminous Road Mix Surface Course," Serial Designation M 63. At least fifty percent of the gravel retained on the No. 4 sieve shall have at least one fractured face. Crushed slag coarse aggregate shall contain no more than twenty percent, by weight, of glass particles. (b) Fine Aggregate

Contrast quote

404 BALLAST AND CRUSHED SURFACING (******) Tacoma

May 15, 2015 · Crushed Surfacing Choker Course shall be seated until no visible movement of aggregate is observed and approved by Engineer. 404.4 Measurement This section is supplemented with the following: "Permeable Ballast Base Course Incl. Haul" and "Crushed Surfacing Choker Course

Contrast quote

3138 AGGREGATE FOR SURFACE AND BASE COURSES

3138 AGGREGATE FOR SURFACE AND BASE COURSES 3138.1 SCOPE This specifiion lists the quality requirements for aggregates used for 2118, 2211, and 2221. 3138.2 REQUIREMENTS A General Use aggregate sources meeting the requirements of 1601, "Source of Supply and Quality." Provide certified aggregate materials that have uniform: appearance

Contrast quote

Chapter 620 Design of Pavement Structure

Consider the inclusion of crushed surfacing top course material for keystone when estimating The specific gravity of the aggregate will affect the weight of aggregate in the completed mix. [2] Quantities shown do not provide for widening, waste from stockpile, or thickened edges. Chapter 620 Design of Pavement Structure WSDOT Design Manual

Contrast quote

Section 306 AGGREGATE SURFACE COURSE

aggregate surface course appliions, compact each layer of aggregate to at least 95 percent of the maximum unit weight, at a moisture content no greater than optimum. Shape the finished surface and layers to within ±½ inch of the crown and grade shown on the plans.

Contrast quote

**********************************************************

UNIFIED FACILITIES GUIDE SPECIFICATIONS 1.3.2 GradedCrushed Aggregate Base Course 1.3.3 Degree of Compaction 1.4 SUBMITTALS 1.5 EQUIPMENT, TOOLS, AND MACHINES surface courses. The following must be taken into consideration when editing this specifiion. a. The material in this specifiion and on the

Contrast quote

UFGS 32 15 00 Aggregate Surfacing WBDG

SECTION 32 15 00 AGGREGATE SURFACING 05/17 ***** NOTE: This guide specifiion covers the requirements for aggregate surfacing for roads, parking areas and Army airfields. Adhere to UFC 130002 Unified Facilities Guide Specifiions (UFGS) Format Standard when editing this guide specifiion or preparing new project specifiion sections.

Contrast quote

Specifiions For CRUSHED AGGREGATE BASE COARSE #2 &

Specifiions For CRUSHED AGGREGATE BASE COARSE #2 & #3 (COMPACTION GRAVEL) Crushed Aggregate Base Coarse (Compaction Gravel) shall consist of one or more courses or layers of coarse aggregate, either crushed gravel or crushed stone, fine aggregate and binder or filler blended as necessary to produce an intimate mixture of the

Contrast quote

ALABAMA DEPARTMENT OF TRANSPORTATION

420 polymer modified open graded friction course 432 423 stone matrix asphalt (sma) 434 424 superpave bituminous concrete base, binder, and wearing surface layers 438 428 scoring bituminous pavement surface 448 429 improved bituminous concrete base, binder, and wearing surface layers 449 430 soil or aggregate type surface 460

Contrast quote

Section 815 Graded Aggregate

Section 815—Graded Aggregate 815.1 General Description This section includes the requirements for material to be used for base, subbase, or shoulder course material, and includes graded aggregate, unconsolidated limerock base, and crushed concrete base. 815.1.01 Related References A. Standard Specifiions Section 800—Coarse Aggregate

Contrast quote

SECTION 02621 AGGREGATE BASE AND SUBBASE

SPECIFICATIONS MAY 1996 SECTION 02621 AGGREGATE BASE AND SUBBASE COURSES 02621.01 GENERAL A. Description Aggregate base and subbase courses shall include, but not necessarily be limited to, furnishing and placing one or more courses of aggregate, including additives when required, on a surface prepared in accordance with the Contract Documents.

Contrast quote

PART IV SURFACE COURSES Louisiana

Aggregate Surface Course 401.01 DESCRIPTION. This work consists of furnishing and constructing aggregate surface courses for shoulders, drives or other facilities in accordance with these specifiions, and in conformity with the lines, grades, thicknesses and typical sections shown on the plans or established. 401.02 MATERIALS.

Contrast quote

Specifiion For Crushed Aggregate Surface Course

SPECIAL SPECIFICATION . 2011 . Crushed Aggregate Base Course . 1. Description. Construct a foundation course for a surface course or for other base courses, composed of crushed aggregate materials as described in this specifiion, in one or more courses, in conformity with the typical sections shown on the plans, and to the lines

Contrast quote

state.mn.us

nonwear mixtures. Do not use crushed concrete in wearing courses. 13.10 Ash Sewage sludge ash and waste incinerator ash are allowed as an aggregate source at a maximum of 5% of the total weight of the mixture. Sewage sludge ash for use as an aggregate source in wear or nonwear courses must

Contrast quote

UFGS 32 15 00 Aggregate Surfacing WBDG

SECTION 32 15 00 AGGREGATE SURFACING 05/17 ***** NOTE: This guide specifiion covers the requirements for aggregate surfacing for roads, parking areas and Army airfields. Adhere to UFC 130002 Unified Facilities Guide Specifiions (UFGS) Format Standard when editing this guide specifiion or preparing new project specifiion sections.

Contrast quote

**********************************************************

UNIFIED FACILITIES GUIDE SPECIFICATIONS 1.3.2 GradedCrushed Aggregate Base Course 1.3.3 Degree of Compaction 1.4 SUBMITTALS 1.5 EQUIPMENT, TOOLS, AND MACHINES surface courses. The following must be taken into consideration when editing this specifiion. a. The material in this specifiion and on the

Contrast quote